The milk in the milk flask is too hot.
Always use cold milk (< 50°F/10°C).
Support for your
Coffee
No milk/milk froth
The coffee machine does not dispense milk or milk froth.
The milk flask is not installed correctly (CVA 7xxx).
Carefully push the milk flask into the coffee machine as far as it will go.
The milk suction tube/stainless steel tube for the milk flask lid is loose or has not been inserted correctly.
Push the milk suction tube onto the milk flask lid as far as it will go.
Make sure that the milk suction tube is stuck on the milk flask lid.
The stainless steel bolt for the milk valve is encrusted with milk residue (CVA 7xxx).
Only remove the milk valve when the coffee machine is switched off. Do not switch on the coffee machine while the milk valve is removed.
Disassemble the milk valve. Proceed as follows:
Press the latches on the left and right-hand sides of the milk valve holder. Pull the holder forward to remove it.
Pull the stainless steel bolt upward and out.
Soak the stainless steel bolt in warm water and a little liquid dish soap.
Clean the stainless steel bolt thoroughly by hand or in the dishwasher.
Assemble the milk valve. Proceed as follows:
Insert the stainless steel bolt from above.
Insert the holder with the silicone seal until it audibly clicks into place.
Make sure that the Rinse milk pipework automatic program is carried out in full.
The milk pipework was connected incorrectly to the central spout (CM 6 and CM 7).
CM 6: The seam on the milk pipework, the central spout, and the rinse valve makes it easier to assemble.
Check that the milk pipework is correctly connected to the central spout.
The milk pipework is blocked.
Clean the central spout and milk pipework carefully with the brush.
Operating Instructions finder
Here you will find the operating instructions for your Miele appliances
Find your manual
